Q:What is a Drill Press
Q: What are the different components of this Drill Press?
Osiris: The first component is called the Quill. This is used to lower the Drill chuck in order to cut.
Q:What is a drill chuck?
Osiris:That piece right there is the drill chuck. In order to use the chuck you must place the point inside the drill chuck and lock it with the chuck key.
Q:where are the Electrical Controls?
Osiris: The controls are on the orange box on the left side of the machine it has a start and stop button to operate the tools.
Q what is that switch next to the electrical controls?
Osiris: This switch is called the fail safe if this plug is not connect the machine the drill press will never work it was made for safety reasons.
Q: What do you lay your equipment on when you are about to cut?
Osiris: This is the table we used to place what we cut onto for it to be stable and me also clamp it down to hold it steady.
Q:Do you place anything ontop of the table?
Osiris: that would on the table we used for support so we dont damage the table.
Q:What did you cut?
Osiris:We Cut the Aluminum we need the edges to be half a circle so we used the drill press to cut the holes.
Q:How do you remove the point from the Chuck?
Osiris:To remove the point You Insert the Chuck Key and turn it in order to release or tighten. the cutting point.
Q:Can you show us the finished metal that you cut?
Pic:
O: This is one of the side that we cut with the drill press and i really liked the out come qith the machine.
No comments:
Post a Comment